The super quiet Enduro Pro SM600-2P Servo Motor pays for itself with a remarkable 60% to 80% energy savings compared to clutch motors. With the high and rising cost of electricity, you just can't afford to run a clutch motor any longer.
The power and dependability of the brushless Enduro Pro SM600-2P is adequate for light duty sewing.
The Enduro Pro SM600-2P Servo Motor is designed to meet almost all basic light duty requirements of various commercial sewing machines. It utilizes extremely powerful rare-earth Neodymium permanent magnets. The motor produces almost no noise, saves energy (60-80%) and is brushless, speed adjustable and durable. It provides a high starting torque even at low speed or from a complete stop.
By using a modern technologically advanced microprocessor, Hall sensor and Pulse-Width Modulation technology, the Enduro Pro SM600-2P can be set to rotate at different maximum speeds, in either normal or reverse directions, and can start with different accelerating speeds. It will stop automatically with any interruption such as in-line voltage, electrical surge, radio frequency interference or overloading. It is fully protected by the software and will give error messages indicating which problem is encountered. It even works well in environments with an unstable electrical power supply.
The Enduro Pro SM600-2P positioner motor comes with a positioner sensor kit included.
The Enduro Pro SM600-2P Servo Motor is covered with a 1 year limited warranty. If the motor fails to perform its designed function due to manufacturer's defects, contact the place you purchased it from for repair or replacement. This warranty does not cover defects due to dropping, power surge, spikes or misuse.
| Additional Information on the Enduro Pro SM600-2P |
| Server Motor with Positioner - 220V
- Single Phase
- Cycles: 50/60
- Variable Speed to 3800 RPM
| Features and Settings: - Motor rotating direction setting
- Slow starting speed
- Maximum speed setting
- Needle Position Setting
|
| Supplied With: - Instruction manual / parts list
- Mounting hardware
- Pulley cover (belt guard)
- 90mm pulley
- Push button on/off wire harness
- Positioner sensor kit
| Additional Information: - Motor Weight: 9 lbs.
- Motor Dimensions:
11.25" L x 7.5" W x 8.5" H - Shipping Weight: 13.201 lbs
- Shipping Dimensions:
14" L x 11.5" W x 10.5" H |
